产品分类
联系我们
Jinan Hongyuan Electric Co., Ltd
Address: No.15 Lanxiang Road, Tianqiao Area,Jinan,Shandong,China
Tel: 0086-0531-88190005
Fax: 0086-0531-58988677
Wechat: ch_rocky
Mobile/Whatsapp: 0086-15254819073
Skype: laser.tube.power.supply
QQ:  2869601953
News center
Notice of Using Co2 Laser Tubes

Using the matters needing attention;
1. During the using, please turn on the cooling water, with the priciples of low into the above output to adjust the position of outlet pipe,to guarantee the cooling water fill the cooling pipe.There is no bubbles in the laser tube, then open the power supply.Requirements: cooling water using soft water (distilled water or pure water), and often pay attention to the temperature of the cooling water temperature should be controlled in 12-30 degrees, may not be too high or too low, especially in the summer, once found, high temperature cooling water should be replaced in a timely manner or stop to rest for a period of time, cooling water shall not be frozen cold regions, especially the laser after downtime, must not let water storage in the laser tube, in order to avoid water ice lead to crack.(special note: the use of alternating current users, cooling water tank must be grounded);


2: laser tube of two supporting points to the laser tube length a quarter point, ensure the flow of cooling water in 2 l - 4 l/min;Otherwise the result is bad, will cause moding, light change several points to lower power;Cooling water nozzle in the tank must be flooded back cover, otherwise, every time close the laser tube cooling water filling and dissatisfaction phenomenon when the phone is switched on.


3: pay attention to protect the laser output window, avoid in the process of the work (including debugging in the process of the optical path) smoke splash to the output window surface and prevents the output window outside surface is pollution, power is reduced, then use absorbent cotton or silk cloth dips in anhydrous alcohol gently wipe the external surface of the output window


4. in the process of debugging, by adjusting the laser tube support or rotating laser tube bearing, in order to achieve the best effect of output, then the laser tube is fixed.
5. please note: to avoid accumulation of dust near high voltage electrode, keep dry, high voltage side as much as possible to stay away from metal, in case of high voltage spark discharge.


6. laser tube in use process, can't have a scale in the cooling tube formation, jams, lest cause cooling water cooling effect.Once found, 20% of dilute hydrochloric acid cleaning cooling pipe, remove scale.


7, laser tube for glass, brittle.Install and use, to avoid the local stress.


8, rational application of laser tube, laser energy saving, the optimal power of the laser tube is itself power less than eighty percent.

[Back]       
MSN online 鲁ICP备05020606 Friendly link